Saramsha

No. 065  ·  20 November 2026

It Turns a Little, Every Click

Press a click pen's button and something turns inside it — a small toothed cam, rotated by exactly half the gap between two teeth, no more and no less. Click once and the moving teeth drop into the valleys of a fixed row beneath them, locked, so the spring can't push the tip back in. Click again and that same half-turn lands the teeth tip to tip instead, with nothing to catch, so the spring wins outright. Press the button and watch the cam decide — then check the tooth row underneath to see why.

The cam, unrolled flat: the top row is the part that turns, the bottom row never moves. Teeth meeting valley-to-peak lock together; teeth meeting tip-to-tip can't hold.

About this piece

A ratchet that never repeats two clicks running

Open a click ballpoint and the part doing all the work is a short plastic tube, usually called the cam or trip tube, fitted around the ink cartridge just behind the button. Its top edge is cut into a ring of identical saw teeth — most consumer pens use somewhere between five and eight. Sitting directly below it, fixed to the barrel and never moving, is a second ring of the same teeth, evenly spaced to match.

Push the button and the cam tube is driven straight down against that fixed ring. The teeth are not cut square; each one has a steep face on one side and a shallow ramp on the other, like a row of tiny right-angled wedges all facing the same way. As the ramps slide past each other under the push, the only way the tube can move is to rotate — the geometry forces it, the same way a wedge forced between two surfaces has to go somewhere. By the time the button has bottomed out, the tube has turned by exactly half the spacing between two teeth. Not a whole tooth. Half of one.

Why half, and not a whole tooth

Release the button and a spring pushes the whole tube back up. What happens next depends entirely on where that half-turn left the teeth. Sometimes it leaves the moving tube's teeth sitting squarely in the valleys of the fixed ring below — interlocked, each tooth braced against its neighbour, with nowhere to go. The spring pushes up and simply can't separate them; the tube is held down, and with it the cartridge, so the ink tip stays out past the end of the barrel, ready to write. Other times the same half-turn leaves the moving teeth sitting directly on top of the fixed teeth's points — tip to tip, nothing to brace against, both sets of points wanting to slide apart the instant there's any force between them. The spring wins cleanly, the tube shoots back up, and the tip disappears into the barrel.

Because every press turns the tube by exactly half a tooth's width, two presses in a row always turn it by one whole tooth — which, since the teeth are identical and evenly spaced, puts it back in the same relationship to the fixed ring it started in. One press can only ever land on the opposite outcome from the press before it. That is the entire reason a click pen alternates: not a spring with two settings, not a hidden switch, just a gear tooth that is deliberately turned by half its own width and nothing more.

The mechanism is sometimes called a trip-cam or rachet-and-cam clicker, and it became common on ballpoints through the 1950s — the Parker Jotter of 1954 is the design most often credited with popularising the satisfying, audible click. A handful of pens use a different idea entirely: twisting the barrel drives the tip along a helical screw thread with no ratchet at all, which is why those never click and never skip a position.

This piece models the cam as six evenly spaced, identical teeth turning by exactly half a pitch per press, which is the standard design and the cleanest to show. Real cams vary in tooth count and in exactly how the ramp geometry is cut, but the half-pitch rotation — and the alternation it guarantees — is the same idea in every click pen built this way.